FD600.1FD1200.1
Specifications1918FD1200.120 Hz > 250Hz>89 dB>NA> 210055Hz - 250Hz.25V - 2.5V0 - 18dB @ 30Hz - 80Hz510 Watts 1010 Watts 1100 Watts
2 3WarningWe build all ARC Audio products to play at high volumes for extended periods of time. Your ears however are not designed for high volume lis
4 5Input SectionBecause of the wide range of head unit output configurations all ARC Audio amplifiers have an adjustable input sensitivity or “Gain”.
6 7BridgingBridging is a way to combine the power of 2 channels into 1. When you wire the amp bridged you have a higher voltage differential between +
8 9Installation Instructions1. Disconnect the negative cable from the car battery. Tape up the end so it is isolated form the battery.2. Run the
SET PHASE TO<INSET LOAD TOTWO>SET INUT TONORMAL>SET PHASE TO<INSET LOAD TO<ONESET INUT TONORMAL>2 OHM OPERATION1 OHM OPERATION2 0HMS
SET PHASE TO<INSET LOAD TOTWO>SET INUT TONORMAL>SET PHASE TOOUT>SET LOAD TOTWO>SET INUT TO<SLAVE4 OHMS BRIDGEDIn this configuration
SET PHASE TO<INSET LOAD TO<ONESET INUT TONORMAL>SET PHASE TOOUT>SET LOAD TO<ONESET INUT TO<SLAVE2 0HMS+-2 OHMS BRIDGED+_10D2 = 212D2
16 17BatteryBatteryBattery orCapacitor4 AWG.18” MAX.4 AWG.18” MAX.18” MAX.18” MAX.4 AWG.18” MAX.4 AWG.4 AWG.4 AWG.4 AWG.FUSEFUSEFUSEREMOTE REMOTEREMOT
Comments to this Manuals